DISASSEMBLY AND ASSEMBLY
AIR INTAKE SHUTOFF (3508)
Remove shaft assembly (9), the spacer and
spring from the housing assembly. Remove the
spring and spacer from the shaft assembly.
If necessary, remove the dowel and remove
lever (10), spacer assembly (12) and pin ( 11 )
as a unit from shaft assembly (9). Remove pin
(11 ) from lever (10) to remove spacer assembly
(12) from lever (10) if necessary.
ASSEMBLE AIR INTAKE SHUTOFF
If necessary, make a replacement of dowel (1)
and make sure the end of the dowel as shown is
83.0 0.5 mm (3.268 .020 in.) below surface
If shaft assembly (2) was disassembled, put
spacer assembly (5) in position on lever (3) and
use a press to install pin (4) until it is even (flush)
with the surface of lever (3) as shown. Put lever
(3), spacer assembly (5) and pin (4) as a unit in
position on shaft assembly (2). Install the dowel
to hold the unit on shaft assembly (2) and put
marks (stake) the end of the dowel.