DISASSEMBLY AND ASSEMBLY
Install the bolts that hold the oil cooler to bracket
(7) and remove the hoist from the oil cooler.
NOTE: Step 4 is for the 3512 Engine.
Make sure the gasket is in place and install the
bolts to hold flange (I I ) and tube (10) to the
water line adapter.
Put clean engine oil on the O-ring seal on elbow
(14). Put elbow (14) in position on the oil cooler
and install the bolts to hold it.
Put clean engine oil on the O-ring seal on the
end of tube (13). Put tube (13) in position in
elbow (14) and install the retainers and bolts to
hold the tube.
Connect oil hose (12) to elbow (14).
Put clips (15) in position on tube (13) and install
the bolt to hold the clips in position.