DISASSEMBLY AND ASSEMBLY
Put clean water on the O-ring seal and put
adapter (10) and the gasket in position in the
front of the aftercooler housings. Install the bolts
to the adapter.
Put clean water on the O-ring seal and push
elbow (9) into adapter (10). Put the gasket in
position between elbow (9) and the tube. Install
the bolts to hold elbow (9) in position.
Install tube assembly (11) on the regulator
housing and adapter (10).
Put clean engine oil on the O-ring seal and install
adapter (12) in the rear of the aftercooler
housings and over the end of the pipe.
Put clean water on the O-ring seal on elbow (14).
Install sleeve (13) and elbow (14) in the rear of
the aftercooler housings. Make sure sleeve ( 13)
is over the end of the pipe and install the bolts to
hold elbow (14).
install air intake shutoff