DISASSEMBLY AND ASSEMBLY
VALVE COVERS, ROCKER SHAFTS AND PUSH RODS
REMOVE VALVE COVERS1107-11
Remove bolts (1) and remove valve cover (2)
from the valve cover base.
If necessary, remove the seal from valve cover,
INSTALL VALVE COVERS
Make sure seal (I) is installed in the groove of
valve cover (3). Cut new seals to fit at assembly.
Put valve cover (3) in position on valve cover
base (2) and install the four bolts to hold it.
Tighten the bolts to a torque of 14 + 3 Nm (10 +
2 lb. ft.).
REMOVE ROCKER SHAFTS AND
1102 & 1208-11
a) remove valve covers
Remove bolts (1) and lift shaft (2) and the rocker
arms off the valve cover base and the push rods.
Remove push rods (3) from the valve lifters and
valve cover base.