DISASSEMBLY AND ASSEMBLY
FUEL INJECTION CONTROL LINKAGE
Remove bolts (9) and the caps that hold the
levers of rod assemblies (8) to the fuel control
If necessary, remove the cover from the front
right side of the flywheel housing and use tool
(B) to turn the engine flywheel until the camshaft
is moved in a position so the levers of rod
assemblies (8) can be removed between the
cylinder block and camshaft.
Remove bolts (11) and remove lever assemblies
(10) and fuel control rod assemblies (8) as a unit
from the cylinder heads. See Step 6 if the levers
on the lower ends of rod assemblies (8) do not
have enough clearance to be removed from the
Remove locknut (12) and the washer to remove
rod assembly (8) from lever assembly (10).
Remove levers (14) from control shafts (1).
Remove the bolts and supports(13) from each
side of the engine.