DISASSEMBLY AND ASSEMBLY
FRONT BALANCER GROUP (3508)
REMOVE FRONT BALANCER GROUP 1220-11
Engine Turning Pinion
a) remove front drive housing
Remove the bolts that hold the brackets for shaft
(2) to the front of the cylinder block. Disconnect
(I) and (3) and remove shaft (2) from the engine.
Use tool (A) to make an alignment of the marks
on balancer gear (4) and crank gear (6)
according to the rotation of the engine as shown.
Remove the bolts and remove plate (5) from
balancer gear (4). Remove balancer gear (4)
from the shaft.
Use tool group (A) and a press to remove
bearing (7) from balancer gear (4).
Remove shaft (8) from the end of the cylinder
Remove crank gear (6) from the end of the