DISASSEMBLY AND ASSEMBLY
REAR GEAR GROUP
REMOVE REAR GEAR GROUP
1P520 Driver Group
a) remove flywheel housing
NOTE: Before the flywheel housing is removed, the
3508 engine must be put in time to make sure the rear
gear group is in alignment according to the rotation of the
engine as shown.
Remove plate (1) to remove gear assembly (2)
from the shaft.
Use tool group (A) and a press to remove
bearing (3) from gear assembly (2).
Use tool group (A) and a press to make a
separation of the gears for gear assembly (2).
Remove the bolts to remove the shafts, gears
(4) and the washers from the cylinder block.