Every 10 Service Hours or Daily
Check Coolant Level
At operating temperature, engine coolant is hot and
Check coolant level only when engine is stopped
and filler cap is cool enough to touch with your
Rotate clutch until lock pin can be reached.
Disengage lock pin and turn adjusting ring clockwise to
increase engagement torque and counterclockwise to
Remove filler cap slowly to relieve pressure.
decrease engagement torque. Turn adjusting ring so
that 345 50 N.m (254 35 lb ft) torque or 636 90 N
Steam can cause personal injury.
(143 20 lb) force at 540 mm (21.3 in) length on lever, is
required to engage the clutch.
Remove filler cap O slowly to relieve pressure.
Inspect condition of cap gasket.
Replace cap if
Lubricate clutch throwout collar .
Maintain coolant level to the bottom of the filler
tube. Install the filler cap.
Lubricate engagement shaft bearing .
Inspect for leaks or damaged hoses.
repairs if necessary.