TM   5-2815-241-34&P FLYWHEEL HOUSING INSTALLATION - CONTINUED ACTION LOCATION ITEM REMARKS NOTE Method  used  for  mounting  dial  indicator  is  at  discretion  of  using  facility.  Position  dial indicator  on  crankshaft  face  and  set  contact  point  of  dial  indicator  on  inner  bore  of flywheel   housing. 5. Flywheel housing (3) Inner  bore  (6) a. Using crankshaft barring tool, rotate crankshaft  until  dial  indicator  is  at 9  o’clock  position  on  flywheel  housing. b. Set dial indicator to zero. c. Using crankshaft barring tool, rotate crankshaft  until  dial  indicator  is  at 3  o’clock  position  on  flywheel  housing. d. Note  that  reading  on  dial  indicator  does not  exceed  0.008  inch  (0.20  mm). If  dial  indicator  reading  meets  or  Is below  specification,  proceed  to  step 7.  If  dial  Indicator  reading  exceeds specification, perform step 6. 8. Cylinder block (1) Flywheel   housing   (1) Using  plastic-faced  hammer,  move  flywheel housing  one-half  of  dial  indicator  reading towards  9  o’clock  position. T A    2 4 2 3 9 6 2-99