CYLINDER HEAD - CONTINUED
To determine amount of cut to injector sleeve seat, measure tip protrusion. See steps 18
When cutting injector sleeve seat, use a solid stream of good cutting fluid to allow cutter
to cut freely without grabbing.
48. Cylinder head (20)
Injector sleeve (21)
Using ST-884 injector sleeve cutter (22)
and suitable drill press, cut injector
sleeve just enough to provide for proper
seating of injector and to maintain correct
injector tip protrusion. See steps 12
If Injector seating area or Injector
tip protrusion are not within specifi-
cations, recut Injector sleeve seat.
T A 2 4 2 4 7 6