TM   5-2815-241-34&P CAM  FOLLOWER  ASSEMBLY This   task   covers: a.  Disassembly  (page  2-254) c.  Inspection  (page  2-256) b.  Cleaning  (page  2-256) d.  Assembly  (page  2-260) INITIAL  SETUP Tools Materials/Parts Cutter,   60-degree   angle   (chamfering cutter) Gage,  plug,  ST-195 Gage,  bore,  dial Gage,  thickness Goggles,  safety Hammer,   ball-peen,   16-ounce Hone,  bushing,  0-  to  1-inch Mandrel  and  block,  ST-249 Mandrel,   plug   driving,   ST-970 Mandrel,   plug   driving,   ST-1053 Micrometer,  0-  to  1-inch Micrometer,  1-  to  2-inch Press,   arbor Press,  drill,  suitable Punch,  center Punch,   drive-pin,   3/32-inch Screwdriver,    flat-tip,    1/4-inch Cloth,  emery  (item  1,  appendix  B) Oil, lubricating (item 12, appendix B) Pin,   roll   (nine   required) Plugs,  cup  (two  required) Prussian  blue  (item  13,  appendix  B) Rags,  wiping  (item  14,  appendix  B) Solvent, drycleaning (item 16, appendix B) Tags,  marker  (item  17,  appendix  B) Equipment   Condition Cam  follower  housing  removed (page  2-47). References TM  55-1500-335-23,  Inspection  Methods, Non-Destructive ACTION LOCATION ITEM REMARKS DISASSEMBLY NOTE Steps given are typical for all three cam follower assemblies. 1.  Cam  follower housing   (1) Cam  follower levers  (2) Tag and number for location. 2-254 Change  1