TM   5-2815-241-34&P LUBRICATING OIL PUMP - CONTINUED ACTION LOCATION ITEM REMARKS 20. Adapter   housing   (8) Install  new  gasket  and  position  adapter and  new  gasket  (9) housing on oil pump body (1). 21. Eight  capscrews  (10) and eight new lockwashers   (11) Using 3/8-inch drive 0 to 100 ft lb (0 to 140 N•m) torque wrench, 6-inch extension, and 1/2-inch socket screw in and tighten to 30 to 35 ft Ibs (42 to 49 N•m). 22. 23. Pressure  regulator cap  (12),  spring (13),  and  plunger  (14) Place in oil pump body. Make  sure  spring  is  in  open  end  of plunger. Screw  (15),  lock plate  (16),  retain- ing yoke (17), and pipe  plug  (18) a. Install  over  pressure  regulator  cap  (12), screw  in  screw,  and,  using  3/8-inch drive 0 to 100 ft lb (0 to 140 N•m) torque wrench  and  9/16-inch  socket,  tighten  to 30 to 35 ft Ibs (42 to 49 N•m). b. Using 6-inch round-nose pliers, bend lock  plate. c.  Using  1/2-inch  hex-head  wrench, screw  in  and  tighten  plug. NOTE FOLLOW-ON   MAINTENANCE: Install  lubricating  oil  pump  (page  2-88). TASK ENDS HERE 2-271