TM   5-2815-241-34&P FUEL  PUMP  -  CONTINUED ACTION LOCATION ITEM REMARKS PULSATION  DAMPER  REPAIR NOTE For  pulsation  damper  removal  procedures,  see  step  3,  page  2-292. 31. Pulsation damper assembly  (7) Fuel inlet connec- tion  (8),  locknut  (9), and   preformed packing  (10) a. Using   1-inch   and   15/16-inch   open-end wrenches,  loosen  locknut. b. Unscrew and remove fuel inlet connec- tion  and  packing. Discard   packing. 32. Elbow  (11) 33. Two  screws  (12),  two lockwashers   (13), two  flat  washers (14),  and  cover  (15) 34.  Cover  (15) Using   7/16-inch   open-end   wrench,   un- screw  and  remove. a.  Using  7/16-inch  open-end  wrench, unscrew  and  remove  two  screws,  two lockwashers,  and  two  flat  washers. b. Take off cover. Discard   lockwashers. Preformed packing  (16) Take  out. Discard. TA   242539 2-301