TM   5-2815-241-34&P FUEL  PUMP  -  CONTINUED ACTION LOCATION ITEM REMARKS 73. Front  cover  (1) Two  oil  seals  (16) Using  arbor  press  and  mandrel,  press  out. Discard. CAUTION Do not use chemical or caustic solutions or solvents that may damage aluminum or aluminum alloy parts. Serious damage to parts will occur. NOTE For  general  cleaning  procedures,  see  General  Maintenance  Instructions,  page  2-3. 74. Front  cover  (1) a. Inspect for cracks, wear, or corrosion. Discard  if  cracked,  worn,  or corroded. b. Inspect  all  mating  surfaces  for  scratch- es,  nicks,  or  burrs. Remove  small  scratches,  nicks,  and burrs  with  emery  cloth. c. Inspect shaft bores and bearing bores for out-of-round   condition. Discard  if  out-of-round. 75. Weight  carrier shaft   bushing   (17) a. Using bore gage, measure inside diameter. Discard  if  worn  more  than  0.504  inch (12.80  mm). b. Inspect  thrust  face  (18)  for  excessive wear. Discard  if  excessively  worn  or scratched. TA  242545 2-311