TM   5-2815-241-34&P FUEL  PUMP  -  CONTINUED ACTION LOCATION ITEM REMARKS 140. Fuel pump housing   (1) Cover  (22),  new gasket  (23),  six screws  (24)  seven new   lockwashers   (25) seven   flat   washers (26),  and  screw  (27) a. b. C. d. e. f. g. Position new gasket on fuel pump hous- ing  alining  holes  with  dowels. Position governor plunger driver and weight  carrier  assembly  horizontally. Hold  governor  weight  carrier  assembly weights  in  and  ready  to  straddle  governor plunger  drive,  while  assembling  cover to fuel pump housing. Make  sure  tachometer  drive  gears mesh  properly. Install  six  new  lockwashers,  six  flat washers, and six screws to fuel pump housing  through  cover. Using   7/16-inch   box-end   wrench, tighten. Install  screw  (27)  new  lockwasher,  and flat  washer  to  fuel  pump  housing  through cover. Using  5/32-inch  hex  key,  screw  in  and tighten. T A    2 4 2 5 5 7 2-331