TM   5-2815-241-34&P SECTION  V,  CRANKCASE  AND  CYLINDER  BLOCK  –  CONTINUED PART  OR  LOCATION Cylinder  Block  Height  From  Main  Bearing Bore  Center  Line From Top of Alinement Bar Cylinder Sleeve Counterbore Cylinder Sleeve Counterbore Shims Part No. 143938 Part No. 143939 Part No. 143946 Part No. 143947 Part  No.  143948 Part No. 143949 Cylinder Sleeve Inside Diameter NEW NEW MINIMUM MAXIMUM 19.004 (482.70) 16.629 (422.38) 0.350 (8.89) 19.006 (482.75) 16.631 (422.43) 0.352 (8.94) 0.0063 (0.160) 0.0072 (0.183) 0.0081 (0.206) 0.018 (0.46) 0.028 (0.71) 0.056 (1.42) 5.4995 (139.687) 0.007 (0.18) 0.0088 (0.223) 0.0099 (0.251) 0.022 (0.56) 0.034 (0.86) 0.068 (1.73) 5.501 (139.73) NOTE New  cylinder  sleeves  dimensions  at  60°  to  70°F  (160°  to  21  °C);  may  be  0.0002  to 0.0006  inch  (0.005  to  0.015  mm)  smaller  than  indicated  due  to  lubrite  coating. Cylinder Sleeve Protrusion Camshaft Journal   Diameter Camshaft  Support  Bushing Camshaft  Outboard  Bearing  Support Gearcase   Cover Accessory  Drive  Bushing Part No. 132770 Part  No.  132771 Part No. 132772 0.003 (0.08) 1.997 (50.72) 1.3725 (34.861) 1.751 (44.48) 1.565 (39.75) 1.555 (39.41) 1.545 (39.24) 0.006 (0.15) 1.998 (50.75) 1.3755 (84.938) 1.754 (44.55) 1.569 (39.85) 1.559 (39.60) 1.549 (39.34) WORN LIMIT 18.994 (482.45) 16.619 (422.12) 0.412 (10.46) 5.505 (139.83) 1.996 (50.70) 1.370 (34.80) 1.757 (44.63) 1.571 (39.90) 1.561 (39.65) 1.551 (39.40) 2-435