TM  5-2815-241-34&P CRANKSHAFT INSTALLATION - CONTINUED ACTION LOCATION ITEM REMARKS 14. Crankshaft   (2) Check  dial  indicator  reading,  while  rotating crankshaft.  Total  reading  should  not  exceed 0.005 inch (0.13 mm). If  total  dial  Indicator  reading  Is  less than  0.005  Inch  (0.13  mm),  perform next  step.  If  reading  exceeds  0.005 Inch  (0.13  mm),  remove  rear  cover and  clean  mating  surfaces.  Perform steps  13  and  14  again. 15. 16. Rear  cover  (8) Eight  screws  (6) New  seal  (10) Using   1/2-inch   drive   9/16-inch   socket   and 0  to  250  ft  lb  (0  to  350  N•m  torque  wrench, tighten to 24 to 29 ft lb (33.6 to 40.6 N•m). Using  seal  mandrel  and  16ounce  ball-peen hammer,  put  in. TASK ENDS HERE TA   242374 2-59