TM 5-3895-360-13
CHAPTER 9
ELECTRICAL SYSTEM MAINTENANCE
Number
Paragraph
Page
Paragraph Title
Number
9-1.
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9-1
9-2.
Ignition Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9-1
9-3.
Sparkplug Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9-5
9-1. GENERAL.
All maintenance procedures in this chapter are to be per-
formed by Unit Maintenance.
9-2. IGNITION REPLACEMENT.
TOOLS:
General mechanic’s tool kit . . . . . . . SC 5180-90-N26
Mechanical puller kit . . . . . . . . . . SC 4910-95-CL-A72
Feeler gage . . . . . . . . . . . . . . . . . SC 4910-95-CL-A72
Multimeter . . . . . . . . . . . . . . . . . . SC 4910-95-CL-A72
Compressor unit . . . . . . . . . . . . . . . . SC 4910-95-A74
REMOVAL
a.
Remove engine starter (see paragraph6-1 ).
NOTE
Refer to Figure 9-1,Fan Housing Replacement,
for steps b through d.
b.
c.
d.
e.
f.
g.
h.
Remove terminal (4) from wire (3).
Remove four nuts (10), Iockwashers (9), washers (8),
and fan housing (1) from crankshaft support (6). Dis-
card lockwashers,
Remove four studs (7) from crankshaft support (6).
Remove grommet (2) and switch (5) from fan housing
(1).
NOTE
Refer to Figure 9-2, Stator Plate Replacement,
for steps f through m.
Remove flywheel (31) and woodruff key (30) from
crankshaft (20). Discard woodruff key.
Move one end of breaker cover spring (25) to the
side and remove cover (29) and gasket (28) from sta-
tor plate (23). Discard gasket.
Remove nut (11), lockwasher (12), connector (13),
and capacitor wire lead (14) from stator plate (23).
Discard iockwasher.
9-1
|
|
