*C2
*C2
C H A P 5, SEC X V I II
R E A R H O U S I N G R E B U I LD
PAR 1 5 6
a i . W h i l e h o l d i n g t h e r i g h t - b r a k e c a m
assembly against spring pressure, install the
follower link shaft (fig. 199).
a j . Install the right-follower link shaft
plug (fig. 200).
a k . T i g h t e n b r a k e a d j u s t i n g n u t s u n t il
they are finger tight (fig. 200). Do not tighten
the nuts enough to move the rotating cam rings.
a l . Install ratchets onto brake links (fig.
2 0 0 ) .
Figure 198. Installing right-brake adjusting nut
Figure 200. Right-and left-brake adjusting nuts and
component parts
Figure 199. Installing right-follower link shaft
a g . I n s t a l l t h e l e f t - f o l l o w e r l i n k s h a f t
plug (fig. 198).
ah. Position the rear housing upright on
assembly table. Assemble items 58 through 71
(fig. 379, fold-out 8) and install as in fig. 198.
Install brake, adjusting nut on the right-brake
apply link, approximately 1/2 inch (fig. 198).
1
3
8
Figure 201. Installing transmission brake air valve
assemblies
|
|
