TM 9-2520-272-34&P 4-15. INSTALL LEFT END COVER ASSEMBLY (SHEET 3 OF 11) Install Range Input Gears, Hydrostatic Drive Gear, Bevel Gear Driven Shaft and Filter Tubes 7    Install  new  packing  (5)  on  end  of  jumper  tube (6). 8    Apply petrolatum to new packing (5). 9    Install  four  new  packings  (7),  two  packings  on filter-in  tube  (8)  and  two  packings  on  filter-out tube (9). 10 Apply petrolatum to new packings (7). NOTE The  filter-in  tube  (8)  is  3.60  inches  (91.44  mm) long. The filter-out tube (9) is 2.25 inches (57.15 mm) long. The    filter-out    tube    (shorter    tube)    is    located closest to the input housing. 11 Install  filter-out  tube  (9)  in  center  housing  (2), either end of tube in first. 12 Install   filter-in   tube   (8)   in   center   housing   (2), either end of tube in first. 13 Install   bevel   gear   driven   shaft   (10)   in   center housing (2), either end of shaft first. 14 Apply  lubricating  oil  and  petrolatum  to  bearing journal   of   range   input   driven   gear   (11)   if   old bearing was removed. NOTE Bearing  (12)  consists  of  cage  and  inner  race. Check    that    outer    race    is    in    left    end    cover assembly. 15 Using  arbor  press,  install  new  bearing  (12)  on range  input  driven  gear  (11).    Press  bearing  to shoulder. 16 Apply lubricating oil to bearing (12). 17 Install  range  input  driven  gear  (11)  over  range input  shaft  on  forward  clutch  housing,  bearing (12) up. Go to Sheet 4 4-58  Change 2 Para.  4-15 Task 1