TM 9-2520-272-34&P
4-15.
INSTALL LEFT END COVER ASSEMBLY
(SHEET 8 OF 11)
NOTE
Transmission does not have to be mounted on
maintenance stand to install oil filter head
assembly. Oil filter head may be removed or
installed with transmission in upright position.
1 Install two new packings (1) on filter head (2).
2 Put petrolatum on new packings (1).
NOTE
Filter element contains packing in each end.
Check that packings are in place before
installing filter.
3 Install new filter element (3) on oil filter head
assembly (2). Push filter element into recess
under filter head until filter element locks to filter
head.
NOTE
Hole in bottom of filter element goes over an oil
tube rising up from the bottom of the filter cavity
in the left end cover.
4 Install filter head (2) with new filter element (3) in
filter cavity on left end cover assembly (4).
5 Using socket, install three bolts (5) and washers
(6) in filter head (2).
6 Using torque wrench, tighten bolts (5) to 27-32
lb-ft (37-43 N’m).
End of Task 3
Go to Sheet 9
Para. 4-15, Task 3
Change 2 4-63
|
|
