TM 9-2520-272-34&P
4-18.
INSTALL TRANSMISSION TOP COMPONENTS
(SHEET 10 OF 16)
TASK 6. INSTALL MAIN CONTROL VALVE ASSEMBLY
COMMON TOOLS:
Extension, socket wrench 1/2 inch square drive, 6 inch
Handle, socket wrench, 1/2 inch square drive
Socket, socket wrench, 1/2 inch square drive, 1/2 inch
Wrench torque, 0-175 ft-lb
SUPPLIES:
Cloth batiste, lint-free (Item 6, Appendix C)
PRELIMINARY PROCEDURE:
Separator plate is
Solenoids A, B, E,
paragraph 4-31.
installed on transmission. Refer to this paragraph, TASK 1.
F and G installed on main control valve assembly. Refer to
CAUTION
Transmission must be in upright position when oil transfer gasket, oil transfer
plate, separator plate, and control valve assemblies are installed. If
transmission is not in vertical position when these items are installed,
misalignment of holes can block oil flow, causing malfunction of transmission.
Care should be taken not to let dust get into control valve assemblies. Keep
top of transmission center housing clean. Keep all parts clean Wipe with
lint-free cloth. Contamination of control valves can cause transmission
failure.
NOTE
One 5/16-18 x 2-3/4 inch bolt and washer at wiring harness ground connector
location are not installed until after wiring harness has been installed. (Refer to
this paragraph TASK 7.)
Go to Sheet 11
Para. 4-18, Task 6
4-89
|
|
