TM   9-2520-272-34&P 4-28. DISASSEMBLE   CENTER   HOUSING (SHEET  1  OF  19) Task Title RIGHT   SIDE   OF   CENTER   HOUSING 1 Remove   Left   Brake   Assembly 2 Remove   Left   Steer   Gear,   Left   Steer   and   Output   Sun   Gear, Left   Output   Shaft,   and   Output   Pump   Drive   Gear 3 Remove   Steer   Control   Assembly 4 Remove   Hydrostatic   Pump   and   Motor   Assembly   (Hydrostat) 5 Remove   Governor   Assembly,   Governor   Body   Assembly, and   Governor   Drive   Gear LEFT   SIDE   OF   CENTER   HOUSING 6 Remove   Range   Pack 7 Remove   Idler   Gear   Assembly TASK   1.   REMOVE   LEFT   BRAKE   ASSEMBLY COMMON    TOOLS: Extension,  socket  wrench  1/2  inch  square  drive,  10  inch Hammer,   hand,   plastic   faced Handle,   socket   wrench   1/2   inch   square   drive Pliers,  long  round  nose Pliers,   retaining   ring,   internal Pry   Bar,   roller   head   (2   required) Screwdriver,   flat   tip,   small Socket,   socket   wrench,   1/2   inch   square   drive,   7/16   inch Socket,   socket   wrench   1/2   inch   square   drive,   1/2   inch Socket,   socket   wrench,   1/2   inch   square   drive,   9/16   inch Socket,   socket   wrench   1/2   inch   square   drive,   5/8   inch SUPPLIES: Rag,   wiping   (Item   15,   Appendix   C) Wooden   blocks,   4   x   4   inches   x   16   inches   long   (2   required)   (Item   3,   Appendix PRELIMINARY   PROCEDURES: 1.   Transmission   top   components   are   removed.   Refer   to   paragraph   4-5. 2.   Right   end   cover   is   removed.   Refer   to   paragraph   4-7. NOTE Transmission   is   on   maintenance   stand,   right   end   turned   up. Go  to  Sheet  2 4-172 Page 4-172 4-177 4-179 4-179 4-181 4-182 4-190 C) Para.  4-28,  Task  1