TM 9-2520-272-34&P
4-30. ASSEMBLE CENTER HOUSING
(SHEET 10 OF 21)
51 Install fourth and reverse clutch assembly (38).
52 Install thrust washer (39) onto clutch assembly (38).
53 Using two screwdrivers, line up fourth and reverse
clutch plates. Install forward clutch housing assembly
(40).
NOTE
If forward clutch does not easily install,
place mating output gear on the hub to use
as a tool to help rock the hub slightly back
and forth and left and right to a seat. The
forward clutch housing is fully seated when
it rocks evenly in all four directions.
54 Rotate forward clutch housing assembly (40) so that
one of the slotted openings is located over the bolt
holes for pitot (41).
55 Install pitot (41). Using socket head screw
attachment, install two screws (42) to hold pitot (41)
in place.
56 Using torque wrench, tighten two screws (42) to
108-132 lb-in (12-15 N•m).
57 Lay fabricated retaining fixture in place on forward
clutch housing (40) and center housing (2).
58 Using 9/16 inch socket, install 3/8-16 x 3/4 inch bolt
(43) to retain retaining fixture.
59 Using rotary control handle on maintenance stand,
turn transmission right end upward.
End of Task 2
Go to Sheet 11
Para. 4-30, Task 2
4-231
|
|
