ASSEMBLE CENTER HOUSING
(SHEET 13 OF 21)
5 Install eyebolt in threaded hole (6) located in shaft on
mounting end of hydrostat (2).
6 Install S-hook in eyebolt and attach hoist; hoist
hydrostat (2) over hydrostat bore in center housing (7).
Center housing is cut away to receive the
raised part of the hydrostat housing where
the steer control assembly will be installed
7 Turn hydrostat (2) so that Platform (8) for steer
control assembly lines up with recess (9) in center
housing. Lower hydrostat into transmission, aligning
gear at base of hydrostat with gear in center housing.
Go to Sheet 14
Para. 4-30, Task 4