TM   9-2520-272-34&P 4-5. REMOVE TRANSMISSION TOP COMPONENTS 5 6 (SHEET 4 OF 8) NOTE Connectors   on   wiring   harness   are   identified by   stamped   letters   on   connectors.   Each connector   will   have   one   of   the   letters   A through   G. Tie   a   cord   to   harness   connector   F   or   G.   When   the harness   is   out   of   the   transmission,   cut   the   cord   off   the connector,   leaving   the   cord   installed   through   the harness   bore.   When   installing   or   replacing   the   harness tie   the   outside   end   of   the   cord   to   connector   F   or   G   and use   inside   end   of   cord   to   pull   harness   through Pulling   on   harness   connector   body   (1)   with   one   hand and   feeding   harness   (4)   through   transmission   with other   hand,   remove   harness   and   gasket   (10)   from transmission REPAIR:  Refer   to   paragraph   4-31   for   repair   of   wiring   harness   assembly. FOLLOW-ON   PROCEDURE:   Install   wiring   harness   Refer   to   paragraph   4-18. End  of  Task  2 TASK   3.   REMOVE   MAIN   CONTROL   VALVE   ASSEMBLY COMMON   TOOLS: Extension,   socket   wrench   1/2   inch   square   drive,   6   inch Handle,   socket   wrench   1/2   inch   square   drive Socket, l l l l socket   wrench   1/2   inch   square   drive,   1/2   inch NOTE Top   cover   assembly   is   removed   from   transmission. Control   valve   assemblies   are   removed   with   solenoids   attached. Wiring   harness   does   not   have   to   be   removed   to   remove   control   valve assemblies. One   bolt   and   washer   were   removed   from   control   valve   assembly   when  harness ground   connector   was   removed. Go  to  Sheet  5 4-8 Para   4-5,   Task   3