TM 9-2520-272-34&P 4-8.  REMOVE LEFT END COVER ASSEMBLY (SHEET 1 OF 10) OVERVIEW Oil filter cover prevents access to two bolts holding left end cover to transmission.  X200-4A Oil Level Fill Tube Assembly must be removed prior to removal of Left End Cover. Task Title Page 1 Remove Oil Level Tube Assembly (X200-4A) 4-27 2 Remove Oil Filter Head Assembly 4-28 3 Remove Left End Cover Assembly 4-28 4 Remove Loose Components, Left End of Transmission 4-30 TASK 1 REMOVE OIL LEVEL TUBE ASSEMBLY (X200-4A) COMMON TOOLS: Wrench, 1-1/4 inch Socket,   socket   wrench,   3/8   inch   square   drive, 9116 inch Extension,  socket  wrench,  1/2  inch  square  drive, 10 inch Handle, socket wrench, 3/8 inch square drive Wrench, 5/16 inch Extension, 3/8 inch square drive Wrench, Key 1/4 1 Remove  oil  level  indicator  (dipstick)  (1)  by  turning ccw. 2 Pull out dipstick (1) from oil tube (2). 3 Using a 1-1/4 wrench, loosen nut (12) retaining oil tube assembly to elbow (11). 4 Using a 9/16 socket extension and handle remove bolt (5) and washer (6) retaining bracket (7) to LH End Cover Assembly (8). 5 Remove  oil  tube  assembly  (2),  bolt  (9),  nut  (10), washer (4), clamp (3), bracket (7) and set aside. NOTE Elbow (part of oil tube assembly) and o- ring, remain in LH End Cover Assembly. 6 Observe position of clamp (3) in relation to oil level tube assembly (2) and mark location. 7 Using  a  5/16  wrench  hold  bolt  (9)  that  retains  the clamp (3) to the bracket (7). Go to Sheet 2 Para.  4-8 Task 1 Change 2  4-27