ARMY TM 9-2805-256-14
AIR FORCE TO 38G2-102-2
NAVY NAVFAC P-8-611-14E
4-18. High Tension Cable.
This task covers:
a . R e m o v al
b. Test/Inspection
c. Installation
INITIAL SETUP
Tools
General Mechanic’s Tool Kit (Item 1, Appendix B)
Multimeter NSN 6625-01-139-2512) (Item 2, Appendix B)
a. R e m o v a l . (figure 4-6)
N O T E
The basic removal and installation procedures are the same for all models of engine.
Loosen two connector nuts (1) on high tension cable (2) and remove cable.
b. T e s t / I n s p e c t i o n .
(1) Perform continuity test between spring ends of cable. Replace cable if no continuity is found.
(2) Perform continuity test between metal cable ends of cable. Replace cable if continuity is not found.
(3) Perform continuity test between spring end and metal cable end. Replace cable if continuity is found.
(4) Replace cable if cut or otherwise damaged.
c.
Installati on. (figure 4-6)
Position cable (2) and secure by tightening two connector nuts
(1).
4 - 18
|
|
