ARMY TM 9-2805-257-14 AIR  FORCE  TO  38G2-103-2 NAVY NAVFAC P-8-612-14E 5-8. Governor  Assembly. This  task  covers: a.  Removal c.  Repair  (breaker  point  ignition) b.  Repair  (breakerless  ignition) d.  Installation INITIAL  SETUP Tools Materials/Parts  (cont) General  Mechanic’s  Tool  Kit  (Item  1,  Appendix  B) Gasket,  Throttle  Housing  to  Carburetor (P/N  9786E65-4) Materials/Parts Gasket,  Throttle  Housing  Front  (P/N  9786E64-6) Gasket,  Throttle  Housing  Rear  (P/N  9786E65-3) Rags, Wiping (Item 6, Appendix D) Solvent,  Drycleaning  (Item  7,  Appendix  D) a. Removal. (figure 5-2) (1) (2) (3) (4) (5) (6) (7) 5-8 Loosen clamp (1) and remove control rod housing (2) from throttle housing (3). Remove  two  screws  (4)  and  washers  (5)  securing  throttle  housing  cover  (6)  and  gasket  (7)  and  remove. Remove screw (8) and washer (9) securing throttle lever (10) to throttle rod (11) and remove. Remove  two  screws  (12)  and  washers  (13)  and  remove  throttle  housing  (3)  gasket  (14)  rear  cover  (15) and gasket (16). NOTE On  engines  with  breaker  point  ignitions  make  note  of  grounding  strap  placement  before removing  screws  securing  governor  assembly. Tag  and  remove  condenser  leads  (17)  and  (18)  from  noise  suppression  filters  (19)  and  (20). Remove  three  screws  (21)  and  washers  (22)  securing  governor  assembly  (23)  and  gasket  (24)  and remove. Remove  old  gasket  from  mating  surfaces.