ARMY TM 9-2805-257-14 AIR  FORCE  TO  38G2-103-2 NAVY  NAVFAC  P-8-612-14E 4-14. Flywheel Cover. This task covers: a.  Removal b. Repair c.  Installation INITIAL  SETUP Tools Materials/Parts General  Mechanic’s  Tool  Kit  (Item  1,  Appendix  B) Rags, Wiping (Item 6, Appendix D) Solvent,  Drycleaning  (Item  7,  Appendix  D) a. Removal. (figure 4-2) NOTE Location and quantity of cable clamps varies from model to model. Note location of cable clamps  before  removing  flywheel  cover. (1) Remove seven screws (1) and washers (2) and pull flywheel cover (3) slightly away from engine (4). NOTE Step 2 applies to engines equipped with breaker point ignition. (2) Remove screw (5), washer (6), and nut (7) and remove cable clamp (8) from ignition switch wiring (9). (3) Tag and remove wiring from ignition switch (10) and remove wiring from flywheel cover (3). b. Repair. (figure 4-2) (1) (2) (3) WARNING Drycleaning  solvent  PD-680  used  to  clean  parts  is  potentially  dangerous  to  personnel  and property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. Flash point of solvent is 100°F-138°F (38°C–60°C). Clean flywheel cover (3) with dry cleaning solvent and dry thoroughly. Remove all dents and repaint flywheel cover as needed. Inspect  rubber  grommet  (11)  and  replace  if  torn  or  otherwise  damaged. c. Installation.   (figure  4-2). (1) Install ignition switch wiring (9) in flywheel cover (3) and secure with screw (5), washer (6), nut (7), and cable  clamp  (8). NOTE Step 2 applies to engines equipped with breakerless ignition. 4-10