ARMY TM 9-2805-258-14
AIR FORCE TO 38G2-89-21
NAVY NAVFAC P-8-614-14E
5-8. Fan Housing.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanic’s Tool Kit (Item 1, Appendix B)
Flywheel removed (para. 5-7).
Regulator-rectifier removed (para. 4-40).
Starter removed (para. 4-39).
a. R e m o v a l . (figure 5-2)
(1)
(2)
(3)
(4)
Remove two screws (1) and washers (2) securing oil pan shroud (3) to fan housing (4).
N O TE
The engine mounts, oil pan baffle and control rod are installed on flywheel fan housing
and do not have to be removed to remove fan housing assembly. Refer to unit
maintenance, Chapter 4 for removal and installation procedures for those items.
Remove six assembled screws and washers (5) and fan housing plate (6) and remove fan housing (4) .
Clean fan housing (4) with drycleaning solvent, and dry thoroughly.
Inspect fan housing (4) and replace if cracked or otherwise damaged,
b.
Installation. (figure 5-2)
(1) Install fan housing (4) and fan housing plate (6) and secure with six assembled screws and washers (5).
(2) Install two screws (1) and washers (2) and secure oil pan shroud (3) to fan housing (4).
5 -6
|
|
