ARMY TM 9-2805-258-14
AIR FORCE TO 38G2-89-21
NAVY NAVFAC P-8-614-14E
5-15. Oil Pan.
This task covers:
a . R e m o v a l
b. Installation
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Tool Kit (Item 1, Appendix B)
Rags, Wiping (Item 7, Appendix D)
Wrench, Torque (NSN 5120-00-853-4538)
Solvent, Drycleaning (Item 8, Appendix D)
(Item 6, Appendix B)
Gasket, Oil Pan Mounting (NSN 5330-00-073-3042)
Equipment Condition:
Oil pan cover and shroud removed (para. 4-22).
a. R e m o v a l . (figure 5-9)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Remove either drain plug (1) or (2) and drain oil into suitable container.
Remove seven assembled screws and washers (3) and remove oil pan
Remove four special studs (7).
(4), gasket (5) and gasket (6).
W A R N I NG
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100°F.-138°F. (38°C.-60°C.).
Clean oil pan (4) with drycleaning solvent and dry thoroughly.
Inspect oil pan (4) and replace if cracked or otherwise damaged.
Remove, inspect and clean drain plugs (1) and (2) and gaskets (8) and replace as needed.
Inspect gasket (6) and replace if ripped or otherwise damaged.
Inspect special studs (7) and replace if damaged.
b . I n s t a l l a t i o n. (figure 5-9)
(1)
(2)
(3)
5 - 2 0
Ensure gasket mating surfaces are clean and old gasket material is removed.
Install oil pan (4), O-ring (6), and gasket (5) and secure with seven assembled screws and washers (3).
Torque screws to 25-30 lb-in. (4469 - 5363 gr cm).
Install drain plugs (1) and (2) and gaskets (8).
|
|
