ARMY TM 9-2805-262-14
AIR FORCE TO 38G2-90-1
NAVY NAVFAC P-8-613-14E
4-41. Oil Filter.
This task covers:
a. Replacement (Element filter)
b. Replacement (Spin or filter type)
General Mechanics Tool Kit (Item 1, Appendix B)
Element, Oil Filter with
Oil Filter Wrench (NSN 5120-00-865-0933)
(Item 2, Appendix B)
Oil Filter, Spin On (P/N 13226E6189)
Oil, Engine (NSN 9150-01-152-4117) (Item 3,
Rags, Wiping (Item 7, Appendix D)
Solvent, Drycleaning (Item 8, Appendix D)
a. Replacement (Elment Filter) . (figure 4-37)
Remove either drain plug (1) or (2) and washer rolled (3) and drain oil into a suitable container.
Loosen screw (4) and remove shell (5) and gasket (6).
Remove element (7) from shell (5), and pour remaining oil into suitable container.
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100°F-138°F (38°C-60°C).
Clean shell (5) and drain plug (1) or (2) with drycleaning solvent, and dry thoroughly.
Inspect shell (5) for cracks, replace if cracked or otherwise damaged.
Inspect drain plug (1) or (2) and washer(3) for wear and replace if worn or otherwise damaged.
Install new element (7) in shell (5).
Install shell (5) and new gasket (6) and secure with screw (4).
Install drain plug (1) or (2) and washer (3).
Fill crankcase (refer to LO9-2805-203-14 for proper grade) and check level.
Start engine, para. 2-9, and run for five minutes and check for leaks.
Stop engine, para. 2-10, recheck engine oil, add oil as needed.