|
|
|
|
|
ARMY TM 9-2805-262-14
AIR FORCE TO 38G2–90-1
NAVY NAVFAC P-8-613-14E
5-12. Ignition Control unit (Breakerless Ignition).
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanic’s Tool Kit (Item 1, Appendix B)
Lower air cleaner duct when removing left hand
electronic ignition control unit (para.4-15).
NOTE
The following procedures are the same for both the left and right hand sides.
a. Removal. (figure 5-9)
(1) Loosen connector nut (1) and remove high tension cable (2).
(2) Loosen connector nut (3) and remove high tension cable (4).
(3) Disconnect low voltage cable (5) from junction box (6).
(4) Remove two screws (7) and washers (8) and remove ignition control unit (9).
b.
Installation. (figure 5-9)
(1) Install ignition control unit (9) and secure with two screws (7) and washers (8).
(2) Connect low voltage cable (5) to junction box (6).
(3) Install high tension cable (4) and tighten connector nut (3).
(4) Install high tension cable (2) and tighten connector nut (1).
5-22
|
|
|
|
|
Privacy Statement -
Copyright Information. -
Contact Us
