TM    9-2815-202-34 c.^Installation NOTE Four bolts (22) and two bolts (23) were installed  in  Para  4-24. (1) (2) (2) (3) (4) (5) (6) (7) (8) (9) Torque four bolts (22) and two bolts (23) to 30-35 Ib-ft (41 -47 N-m). Install four bolts (20) and four Iockwashers  (21),  fastening  mounting bracket  (19)  to  flywheel  housing. Torque four bolts to 30-35 Ib-ft (41-47 N-m). Start three bolts (17) and three Iockwashers  (18)  securing  exhaust tee (11 ) to mounting bracket (19). Install exhaust tubes (14 and 15) and four  clamps  (13)  between  exhaust  tee (11)  and  exhaust  manifolds  (16). Tighten four clamps then torque three bolts (17) to 30-35 Ib-ft (41-47 N-m). Position a gasket (12) on exhaust tee (11), Remove  protective  covering  from bottom of turbocharger (7) and position on exhaust tee (11). Install four locking nuts (9) and four flat  washers  (10)  securing turbocharger (7) to exhaust tee (11). Torque nuts to 35-39 Ib-ft (47-53 N-m). Slide  two  hose  connectors  (5)  and four clamps (4) onto air inlet tube (6). Install air inlet tube (6) between turbocharger  (7)  and  air  inlet  housing (8). Tighten hose clamps (4). Install two hoses (2) and four clamps (1) onto turbocharger oil drain tube (3). Connect end of oil drain tube to turbocharger  drain  and  other  end  to left side outboard flywheel housing cover. Tighten four clamps (1). END OF TASK FOLLOW-ON  MAINTENANCE Para   Description 3-11    Install turbocharger oil supply line 4-5