TM9-2815-202-34 4-10.   AIR   BOX   HEATER   REPLACEMENT   (Cont) f. Installation (1) (2) (3) (4) Secure wiring harness connectors (62 and 63) to air inlet housing with two bolts (59), two Iockwashers (60), and two flat washers (61). Torque bolts to 16-20 Ib-ft (22-27 N-m). Install hose (50) onto elbow (49) on solenoid valve (52). Position  solenoid  valve  and  bracket  assembly  (66)  on  governor  housing  and  inboard  of bracket (67). Route harness wiring to prevent cuts, chaffing, burns, or interference with components.  Loosely  secure  assembly  to  governor  housing  with  two  screw  assemblies  (68) and four flat washers (69). Install two bolts (64) and assembly (66) to support assemblies  (68). two  Iockwashers  (65)  securing  solenoid  valve  and  bracket (67). Torque bolts to 30-35 Ib-ft (41 -47 N-m). Tighten two screw NOTE (5) (6) (7) l Tee (53) is on the front of the left cylinder head on model 7083-7395 and on the inside rear of the left cylinder head on model 7083-7396. l For  model  7083-7396,  position  arms  of  tee  (53)  at  12  o’clock  and  3  o’clock  positions. (8) (9) (10) Install tee (53) into left cylinder head. For model 7083-7395, install connector (55) to tee (53). For model 7083-7396, install elbow (58), check valve (57), and connector (56) to tee (53). NOTE Model 7083-7396 has no clamp (6) on hose (50) and uses a connector (49) instead of an elbow (49) on the solenoid inlet. For model 7083-7395, install hose (50) into tee (53) on left cylinder head. If removed, install clamp (6) on hose (50) and secure to governor cover using screw assembly (8). For model 7083-7396, install hose (50) into connector (54) in tee (53) on left cylinder head. Install hose (32) onto elbow (51) on solenoid valve (52). NOTE Install air pump, ignition coil, and air box heater after installation of solenoid valve and bracket. 4-34