TM   9-2815-202-34 (7) (8) (9) (11) (12) Remove four clamps (1) and two hoses (2) from left and right governor fuel rod tubes (3). Discard hoses. Remove  two  clamps  (8)  and  blower drive hose (9) from flange (17). Remove cover (18) from inside of hose (9), Discard hose. Remove tube (6) with oil tube nuts (4 and 5). Remove oil tube fitting (7). Remove bolts (19 and 20) and two copper  washers  (21)  from  governor assembly.  Discard  copper  washers. NOTE Two  bolts  (22)  are  inside  governor  housing  assembly. Remove eight bolts (22), eight Iockwashers (23), and eight washers (24). Discard Iockwashers. Tap sides of governor housing (25) lightly with soft hammer to loosen governor from blower. Remove  governor  housing  (25)  and  gasket  (26)  from  blower  housing  (12).  Discard  gasket. (13) b.  Installation (1) (2) (3) (4) (5) Position governor to blower gasket (26) on blower housing (12). Install  governor  housing  (25)  on  blower  housing  (12). Install bolt (19) and copper washer (21). Torque bolt to 13-17 Ib-ft (18-23 N-m). Install bolt (20) and copper washer (21). Torque bolt to 13-17 Ib-ft (18-23 N-m). Install eight bolts (22), eight Iockwashers (23), and eight washers (24). Torque bolt to 13-17 Ib-ft (18-23 N-m). Change   1^4-59