TM 9-2815-202-34 4-41.  BLOWER  REPAIR This  task  covers: a.   Disassembly b.   Cleaning c.   Inspection d.   Assembly INITIAL  SETUP MODELS MANDATORY  REPLACEMENT  PARTS All 16 12 1 1 TOOLS AND SPECIAL TOOLS 4 1 General mechanics tool kit (App B, Item 96) Gear and bearing puller (App B, Item 94) Oil   seal   installer   App  B,   Item   94) Seal ring carrier adaptor (App B, Item 94) Oversized seal pilot (App B, Item 94) Seal ring installer (App B, item 94) Gage set (App B, Item 26) Torque wrench (App B, Item 101) Dial indicator (App B, Item 44) Tachometer  drive  alignment  tools (App B, Item 5) l Lip type oil seal (replacement part) l * Ring type oil seal (replacement part) Lockwashers (App F, Item 92) Lockwashers (App F, Item 91) Gasket (App F, Item 56) Key washer (App F, Item 166) Seals ** (App F, Item 145) Seal set* (App F, Item 156) EXPENDABLE/DURABLE    SUPPLIES 5 Bolts 5/16-24 x 1 1/2 inch (App C, Item 3) 2 Wood blocks (App C, Item 46) Engine oil (App C, Item 16) 4 Bolts 5/16-18 x 1 7/8 (App C, Item 2) 4 Washers 5/16 (App C, Item 18) Form-A-Gasket sealant (App C, Item 39) EQUIPMENT  CONDITION 4-12   Fuel   pump   removed 4-17  Governor  cover  and  throttle  control rod  removed 4-18   Governor   and   blower   assembly removed a.  Disassembly NOTE Matchmark blower housing to front and rear end plates before disassembly. (1) (2) Remove ten bolts (1), ten lockwashers (2), and ten special washers (3) from blower end plate cover (4). Discard Iockwashers. Remove blower end plate cover (4) and gasket (5). Discard gasket. Change  1 4-235