TM   9-2815-202-34 5-41.   GOVERNOR   REPAIR This task covers: a.  Disassembly b. Cleaning/Inspection c.  -Assembly INITIAL   SETUP MODELS 7083-7391 7083-7396 7083-7399 TOOLS  AND  SPECIAL  TOOLS General mechanics tool kit (App B, Item 96) Governor cover bushing remover (App B, Item 78) Governor cover bearing installer (App B, Item 77) Governor cover bushing installer (App B, Item 53) Torque wrench (App B, Item 101) EXPENDABLE/DURABLE    SUPPLIES Sealant (App C, Item 38) Grease (App C, Item 22) Sealant (App C, Item 40) Engine oil (App C, Item 16) Cleaning solvent (App C, Item 10) Bolt 5/1 6-24 x 3 (App C, Item 4) EQUIPMENT  CONDITION Para   Description 5-17 Governor removed from blower MANDATORY  REPLACEMENT  PARTS 1 Seal ring (App F, Item 131) 1 Seal ring (App F, Item 132) 1 Gasket (App F, [tern 78) 1 Gasket (App F, Item 82) 1 Key washer (App F, Item 165) 1  Expansion  plug  (App  F,  Item  113) 1 Washer (App F, Item 161) a.   Disassembly NOTE l Before and during disassembly of governor, clean entire unit and visually  inspect  for  repairs  of worn or damaged parts not requiring  complete  disassembly. l If remote control levers are on governor  cover,  remove  prior  to disassembly  of  cover. (1) (2) (3) (4) 5-64.2 Remove  eight  screws  (1)  securing governor cover (2) to governor (3). Remove cover and gasket (4). Discard  gasket. Remove retaining ring (5) and two washers (6) from stop lever shaft (7). Remove stop lever shaft (7) and return spring (8) from governor cover (2). Remove seal ring (9) from governor cover (2). Discard seal ring (9). Change  1