TM  9-2815-202-34 5-41.  GOVERNOR  REPAIR  (Cont) (17) (18) (19) (20) (21) (22) (23) Remove plug (31) and gasket (32). Discard  gasket. Bend tang of key washer (33) away from retainer bolt (34). While holding weight carrier (35), remove  retainer  bolt  (34),  washer  (36) and  key  washer  (33).  Discard  key washer. Thread a 5/16-24 x 3 inch bolt (37) into hole for retainer bolt (34). Remove  governor  housing  (3)  from vise. Place governor housing (3) on a flat surface with bolt (37) facing up. Tap weight carrier shaft (38) out of bearing (39)  with  a  soft-headed  hammer. Slide riser bearing (40) and riser (41 ) off weight carrier shaft (38). (24) (25) (26) (27) (28) NOTE Inspect  weight  carrier  bearing  in governor housing to determine need  for  removal. If  necessary,  remove  weight  carrier bearing (39) from governor housing (3). Use a small brass rod and hammer to tap bearing from inside housing. Matchmark  two  high  speed  and  two low speed weights (42 and 43) to weight  carrier  (44). Remove four retaining rings (45). Press two pins (46) from weight carrier  (44)  and  remove  two  washers (47), two high speed weights (42), and  low  speed  weights  (43). Using  bearing  remover  (48),  sleeve (49)  and  arbor  press,  remove  needle bearing (50) from one high speed weigh{;   Repeat   procedure   for other  high  speed  weight. 5-66