(29)
(30)
(31)
(32)
(33)
(34)
(35)
(36)
(37)
TM 9-2815 -202-34
Using an arbor press, remove carrier shaft (51) from weight carrier (44) by placing spline end
into a sleeve (52) having a one-inch hole.
Remove retaining clip (53) and washer (54) from differential lever pin (55) and remove
operating lever connecting link (56).
Remove retaining clip (57) and washer (58) from operating lever pin (59). Remove
differential lever (60) from operating lever (61).
If damaged, remove pin (55) from differential lever (60).
For models 7083-7391 and 7083-7396, remove two springs (62) and two retainer clips (63).
Separate governor links (64 and 65) and remove pin (66).
Loosen locknut (67) and remove buffer screw assembly (68).
Remove screw and washer assembly (69) and locking clip (70) securing operating lever
shaft (71) to governor housing (3).
Remove operating lever shaft (71), control link operating lever (72) and two washers (73).
If bearings are damaged, support control link operating lever (72) on sleeve and rest sleeve
on bed of arbor press. Place bearing remover (48) on top of bearing (74) and press two
bearings (74) out of operating lever (72).
C h a n g e 15-67
|
|
