TM    9-2815-202-34 (35) (36) (37) (38) (39) (40) (41) (42) (43) (44) (45) (46) (47) Place key washer (33) on end of carrier shaft (38) with tang on inner diameter of washer in notch in end of carrier shaft (38). Install  washer  (36)  and  retaining  bolt (34). Torque bolt to 15-19 Ib-ft (20-26 N-m). Bend tang on key washer (33) against head of bolt. Install  washer  (32)  against  bearing (39). Apply sealant to threads of plug (31) and  install  in  governor  housing  (3). Torque plug to 45 Ib-ft (61 N-m). Thread retainer nut (21 ) onto retainer (22) 1.5 inches. Install high speed spring (30) on plunger (23) and insert into retainer (22). Thread  screw  (28)  0.5  inch,  through retainer  (22),  into  threaded  end  of plunger (23) and install nut (29) onto screw (28) until it contacts end of plunger. Insert low speed spring (25) into low speed spring cap (24). Place small end of spring seat (26) into low speed spring (25). Place adjusting pin (27) into spring seat. Install  adjusting  pin  (27),  spring  seat (26),  low  speed  spring  (25),  and  low speed spring cap (24) into plunger (23). Place gasket (20) on shoulder of retainer nut (21 ) and install high speed spring retainer (22) and plunger (23) assembly into governor housing  (3)  1.0  inch.  Tighten  retainer nut. Fasten  access  cover  (19)  to  governor (3) with two bolts (17) and two flat washers  (18).  Tighten  bolts. Place governor cover (2) in press with top facing up. Using  bushing  installer  (90),  press two  bushings  (16),  numbered  side  up, into governor cover (2) until flush. 5-73