(2) (3) TM9-2815-202-34 Install gasket (24) and tube (21 ) onto block. Secure with two bolts (22), two Iockwashers (19), and flat washer (23). Torque bolts to 30-35 Ib-ft (41 -47 N-m). If removed, install clip (20) onto tube (21). Secure clip and tube on flywheel housing with bolt (17), Iockwasher (19), and nut (18). Torque bolt to 30-35 Ib-ft (41-47 N-m). END OF TASK FOLLOW-ON  MAINTENANCE Para   Description 6-14 Install air inlet housing 6-17.  BLOWER  DRIVE  SHAFT  AND  HUB  REPLACEMENT (See Para 4-16) 6-18.  GOVERNOR  COVER  AND  THROTTLE  CONTROL (See Para 4-17) ROD   REMOVAL/lNSTALLATION 6-19. GOVERNOR AND BLOWER ASSEMBLY REMOVAL/lNSTALLATION        (See Para 4-1 8) 6-20.  BLOWER  DRIVE  GEAR  AND  SUPPORT  REPLACEMENT (See Para 4-19) 6-21.  OIL  PAN  REPLACEMENT (See Para 4-20) 6-22.  CAMSHAFT  FRONT  GEAR  COVER  REPLACEMENT (See Para 4-21) 6-23.   FLYWHEEL   ASSEMBLY   REPLACEMENT (See Para 4-22) 6-24.  REAR  OIL  SEAL  REPLACEMENT (See Para 4-23) 6-25.   FLYWHEEL   HOUSING   REPLACEMENT (See Para 4-24) 6-26.  IDLER  GEAR  REPLACEMENT (See Para 4-25) 6-27.  INJECTOR  CONTROL  TUBE  REPLACEMENT (See Para 4-26) 6-28.   CYLINDER   HEAD   ASSEMBLY   REMOVAL/lNSTALLATION (See Para 4-27) 6-29.  ENGINE  LOWER  FRONT  COVER  REPLACEMENT (See Para 4-28) 6-30.   CAMSHAFT   AND   GEAR   ASSEMBLIES   REPLACEMENT (See Para 4-29) 6-31.   CYLINDER   BLOCK   END   PLATES   REPLACEMENT (See Para 4-30) 6-32.  OIL  PRESSURE  REGULATOR  AND  RELIEF  VALVE REPLACEMENT 6-33.   OIL   PUMP   REPLACEMENT (See Para 4-31) (See Para 4-32) 6-29