TM9-2815-202-34 SECTtON   W.   E?4G1NE   TESTthIG 8-14.  CYLINDER  COMPRESS1ON    T E S T Tl?istaskcovcws:  Testing IN!TIAL   SETUP MODELS EXPENDABL13’W  RABLE SUPPLIES TOOM AND  SPECIAL TCKM Gemr~  mechanics  toot kit (~ B, CyMder adapter (App B, km 90] Cylinder  tester (App B, Item 90) Fuel nut wench  Moo  B, kern 99 1 Spare  fuel line (@p C, Rem 20) EQUIPMENT  CONDITION Pam Description kern 96) 4-11  Rocker  arm  cove=    removed Twbochaqer  inkt ‘khie~ (~ B, kern 81 ) Torque wench  (Aw B,  ttem 100) Torque wrench (@p B, Item  101) Testing l l l WARMING Avoid   contact   m-th hot manifcdds,  pulley% avoid  personal  Injuq. Wear  proper  ear  protection  when  running engine  can  cause  hearing  loss  or  injury. and other  moving  ~ to engine.  Noise  volume  of Protective  turbocharger  air  inlet  shield  must  be  instaJted  prior to doing maintenance  when  e-’hgine  is  running  and  air  inlet  has  been  removed. Contact  with  rotating  blades  will  cause  injury  to  personnel. CAUTION RUFI engine in dean area  when air intake dwthg is  removed.  DirL dust  and parfkks in WVtered  air can enter  engine  and &rn*e parts or cawe  mechanical  failure. NOTE Start engine and operate  unti~ coolant operating  temperature is 165-185’F (71.1- 85.0°C). Stop engine and remove rocker arm covers. a. Move governor control  lever (1) to NO FUEL IxM&M?. b. Loosen  four fuel line nuts  (2) and remove two fuel Wws (3). . 8-34 Chame  1