(j) Wash exterior of engine using water under pressure to remove dirt and mud.
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective
goggles and gloves and use only in a well-ventilated area. Avoid contact
with skin, eyes, and clothes and do not breathe vapors. Do not use near
open flame or excessive heat. The flash point is 100°F-138°F
(38oC-50oC). If you become dizzy while using cleaning solvent, get fresh
air immediately and get medical aid. If contact with eyes is made, wash
your eyes with water and get medical aid immediately.
(k) Remove oil and grease by using a stiff brush and cleaning solvent.
Compressed air used for cleaning purposes will not exceed 30 PSI. Use
only with effective chip guarding and personal protective equipment
(goggles/shield, gloves, etc.)
(l) Remove moisture from engine by blowing off with compressed air.
b. Preliminary Inspection
(a) After engine has been thoroughly drained and cleaned, inspect external areas of engine
to determine leaks, broken or cracked areas and missing parts.
(b) Visually inspect external components for bent, broken or other damaged conditions.
(c) Mark faulty areas with chalk or crayon to serve as a guide in repair or replacement of
END OF TASK