SERVICE UPON RECEIPT
Initial Starting and Break-in
Engine may contain preservative oil upon receipt.
Preservative engine oils PE1 and PE2 are identical to
engine oils OE-10 and OE-30 except that they
contain a preservative additive.
PE1 and PE2 will be used in the same manner as the
regularly used engine oils OE-10 and OE-30 until the
first semiannual oil change.
Due to international processing, engine may be hard
to start and may smoke and run rough. Let it run
for 5 minutes and see if it improves. Perform
troubleshooting procedures if engine fails to develop
full power after 5 minutes.
Start and run engine until preservative oil is out of
combustion chambers and engine is operating
smoothly. Check for fuel and oil leaks immediately.
Test engine systems for proper operation (refer to Work Package 0044).
Equipment faults disclosed during preliminary inspection and servicing or during break-in period
will be corrected by the using unit or support maintenance.
Serious equipment faults that appear to involve unsatisfactory design or material will be reported
on SF 368, Quality Deficiency Report (Category II), as prescribed in DA PAM 738-750.
END OF WORK PACKAGE
WP 0027 00-2