FLYWHEEL AND SPUR GEAR REPLACEMENT (2CA, 2DA)
Flywheel is heavy. Be sure that lifting device is attached and do not
allow flywheel to swing about uncontrolled. Failure to comply may
result in personal injury.
4. Pull flywheel (2).
a. Install three of the removed mounting screws (4) into puller holes provided in
Use care in removing flywheel from dowel pins so as not to cause
binding. Damage may occur to dowel pin or flywheel hole.
b. Alternately tighten three screws (4) to
pull flywheel (2) just enough to install
eyebolt (6) (item 65, WP 0176).
c. Attach a suitable lifting device (7) to
eyebolt (6) and take out slack.
d. Continue to alternately tighten screws (4)
until flywheel (2) is free from dowel
pins (8) in crankshaft.
e. Place flywheel on wooden pallet or other
suitable safe location, then remove three
screws (4) and eyebolt (6).
WP 0102 00-3