ROCKER ARM ASSEMBLY AND COVER REPLACEMENT
Step 3 applies to both sides of all except the end cylinders. On the end
cylinders (1 and 6, left and right), step 3 applies to the inboard side
Inter-cylinder sleeves are made of a rubber-type material and are
easily damaged. The cylinder and rocker cover are made of
aluminum and also are easily damaged. Take care when separating
the sleeve from the cylinder not to damage either. Failure to comply
may result in an oil leak.
3. Loosen inter-cylinder sleeves (6).
a. Remove the top screw (7A), and loosen the bottom two screws (7) securing the flange (8)
to the cylinder (9).
b. Move flange (8) away from cylinder (9) as far as the loosened screws will allow.
c. Using a piece of shim stock or other suitable tool, carefully separate inter- cylinder
sleeve (6) from cylinder.
WP 0104 00-3