ROCKER ARM ASSEMBLY AND COVER REPLACEMENT
Step 4 applies only to cylinder number 6 left and right.
There is a concealed O-ring in the camshaft drive housing where the
housing mates to the cylinder. Be careful not to damage this O-ring
when separating the housing from the cylinder. If O-ring is damaged,
camshaft will have to be removed to replace the O-ring (refer to
General Support WP 0146).
4. Separate camshaft drive housing (10) from rocker arm cover (11).
a. Remove top screw (7A) and loosen two lower screws (7) on outboard side of rocker arm
b. Carefully separate housing (10) from rocker arm cover assembly (11) being careful not to
damage O-ring (12).
12 (concealed O-ring)
WP 0104 00-4