FUEL INJECTION TUBES REPLACEMENT
Support nuts (1) on ends of each
fuel injection tube must be
tightened after the compression
nut (2) [nozzle end] or
compression connector (3) [pump
end] has been torque tightened.
The compression nut or
compression connector must be
held in place while tightening the
support nut. Failure to comply
may result in damage to fuel
21. Tighten injector tube compression nuts (2) to
300 inch-pounds (34 Nm) at each
22. Tighten support nuts (1) to 125 inch-pounds
(14 Nm) at each nozzle (17).
Inspect all lines and clamps for 1/8 inch (3.175 mm) minimum
clearance with exhaust manifold, fan towers, and cooling fans.
Contact of fuel lines to each other is not permissible.
END OF WORK PACKAGE
WP 0113 00-15 (16 blank)